diff --git a/README.md b/README.md
index 006d3dc9cee761c36e278b4c3e74293180f3847a..418c569b5e35ed0b20d683416af43da8a4647b35 100644
--- a/README.md
+++ b/README.md
@@ -28,11 +28,13 @@ We toolpathed the microspline part at the full ~2" long scale. This would be cut
 
 Given the long machining time, we ultimately decided to do a 1/3-scale test cut from a stack of 0.01" brass sandwiched between 0.25" aluminum. The perimeter of this toolpath measures 17.5 inches. With an expected cut speed of 0.18 inches/minute, the expected cut time is just about 100 minutes or 1 hr 40 mins.
 
-## Micromachining
+## Micromachining using Zund G-3 L-2500
 
-Using a .030" diameter end mill with amorphous diamond coating (<a href='http://www.harveytool.com/ToolTechInfo.aspx?ToolNumber=72030-C4'>Harvey Tool 72030-C4</a>), we machined the flexure from .020" Aluminum 2024 sheet in 2.5 minutes (comparable to the waterjet).
+Despite being a very large-scale tool, the Zund was surprisingly effective at micromachining with its 50kRPM router spindle.  To fixture the stock, we first faced a sheet of aluminum to provide a rigid surface.  Then we applied PSA tape to both this surface and the underside of the stock.  We burnished the tape using a small stainless rod.  Then we applied CA glue to the tape and bonded the stock to the substrate.
 
-Here is a 50% scale flexure (.010" beams, .015" gaps) machined from .020" thick Aluminum 2024 sheet using a .015" diameter end mill with amorphous diamond coating (<a href='http://www.harveytool.com/ToolTechInfo.aspx?ToolNumber=72015-C4'>Harvey Tool 72015-C4</a>).  It was fixtured using burnished PSA tape to both the substrate and the stock, with CA superglue applied between the tape layers.
+Using a .030" diameter end mill with amorphous diamond coating (<a href='http://www.harveytool.com/ToolTechInfo.aspx?ToolNumber=72030-C4'>Harvey Tool 72030-C4</a>), we machined the flexure from .020" Aluminum 2024 sheet in 2.5 minutes (comparable to the waterjet).  300um step down, 20 mm/s, 50kRPM.
+
+Here is a 50% scale flexure (.010" beams, .015" gaps) machined from .020" thick Aluminum 2024 sheet using a .015" diameter end mill with amorphous diamond coating (<a href='http://www.harveytool.com/ToolTechInfo.aspx?ToolNumber=72015-C4'>Harvey Tool 72015-C4</a>).  This took about 8 minutes, but I think could be run faster.
 
 <img src='images/flexure-0.5-penny.jpg' width=300px>